Skip to main content
Tagasi

EVS-EN ISO 105-B06:2004

Textiles - Tests for colour fastness - Part B06: Colour fastness and ageing to artificial light at high temperatures: Xenon arc fading lamp test

Üldinfo

Kehtetu alates 16.07.2020
Alusdokumendid
ISO 105-B06:1998 + A1:2002; EN ISO 105-B06:2004
Tegevusala (ICS grupid)
59.080.01 Tekstiil üldiselt
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
16.07.2020
Põhitekst
09.08.2004
Põhitekst
This part of ISO 105 specifies a method for determining the colour fastness and ageing properties of all kinds and forms of dyed and printed textiles and/or other organic substrates under the action of an artificial light source representative of natural daylight (D65), and under the simultaneous action of heat. Of the four different sets of exposure conditions specified (see 6.1), three use D65, and the fourth a somewhat lower cut-off wavelength. The test method gives special consideration to the light and heat conditions that occur in the interior of a motor vehicle. The four different sets of conditions specified are known to give similar but not necessarily identical results.

Nõutud väljad on tähistatud *

*
*
*
PDF
19,84 € koos KM-ga
Paber
19,84 € koos KM-ga
Sirvi standardit alates 2,48 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 105-B10:2011

Tekstiil. Värvipüsivuse katsed. Osa B10: Ilmastikumõjutuste imiteerimine. Mõjutamine filtreeritud ksenoonkaarekiirgusega (ISO 105-B10:2011)
Uusim versioon Kehtiv alates 02.11.2011
Põhitekst

EVS-EN ISO 10724-1:2002

Plastics - Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) - Part 1: General principles and moulding of multipurpose test specimen
Uusim versioon Kehtiv alates 05.03.2002
Põhitekst

EVS-EN ISO 179-1:2010

Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
Kehtetu alates 03.07.2023
Põhitekst

EVS-EN ISO 294-5:2013

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2011)
Kehtetu alates 02.01.2018